Kohler K-108 Instrucciones De Instalación página 3

DETERMINE YOUR DRAIN STYLE AND FOLLOW THE APPROPRIATE INSTALLATION
STEPS.
DRAIN (CP AND PB FINISHES)
S Remove the protective seal from the flange.
S Apply a 1/2" (1.3cm) diameter ring of plumbers putty
or other sealant around the underside of the flange
according to the putty manufacturer's instructions.
Insert the flange into the lavatory drain hole.
S Assemble the gasket (tapered side up) and
washer to the flange, and partially thread the nut
to the flange. Do not fully tighten the nut at this
time.
S Install the body washer and body to the flange,
and wrench tighten.
S Position the body so the seal hole is facing
toward the back of the lavatory.
S Handtighten the nut.
S Remove any excess putty or sealant.
DRAIN (OTHER FINISHES)
S Remove the flange from the body.
S Thread the nut completely onto the body.
S Apply a 1/2" (1.3cm) diameter ring of plumbers putty
or other sealant to the underside of the drain flange
according to the putty manufacturer's instructions.
S Insert the drain body up into the underside of the
lavatory drain hole.
S Position the body so the seal hole is facing toward
the back of the lavatory.
S Thread the flange onto the drain body from the
topside of the lavatory.
S Securely handtighten the nut from the underside of
the lavatory.
S Remove any excess putty or sealant.
S Assemble the nylon washer, metal washer, and
nut onto the long end of the rod.
S Assemble the nylon washer and rubber washer
onto the short end of the rod.
Kohler Co., Kohler, WI U.S.A.
Seal Hole
Flange
Apply Plumbers
Putty
Seal
Hole Body
Nut
Metal Washer
Nylon Washer
Nut
Nylon Washer
Rubber Washer
3
Flange
Apply Plumbers Putty
Gasket
Washer
Nut
Body Washer
Body
Lavatory
Underside
Rod
A
1010441-2-