Important Remarks - V2 ELETTRONICA PRGU433PP Manual De Instrucciones

IMPORTANT REMARKS

For any installation problems please contact V2 ELETTRONICA
TEL. (+39) 01 72 81 24 11
V2 ELETTRONICA has the right to modify the product without previous notice; it
also declines any responsibility to damage or injury to people or things caused by
improper use or wrong installation.
Please read this instruction manual very carefully before installing and
programming your control unit.
• This instruction manual is only for qualified technicians, who specialize in
installations and automations.
• The contents of this instruction manual do not concern the end user.
• Every programming and/or every maintenance service should be done only by
qualified technicians.
AUTOMATION MUST BE IMPLEMENTED IN COMPLIANCE WITH THE EUROPEAN
REGULATIONS IN FORCE:
EN 60204-1
(Machinery safety. electrical equipment of machines, part 1: general rules)
EN 12445 (Safe use of automated locking devices, test methods)
EN 12453
(Safe use of automated locking devices, requirements)
• The installer must provide for a device (es. magnetotermical switch) ensuring the
omnipolar sectioning of the equipment from the power supply. The standards require a
separation of the contacts of at least 3 mm in each pole (EN 60335-1).
• After making connections on the terminal board, use one hose clamp to fix dangerous
voltage wires near the terminal board and another hose clamp to fix safety low voltage
wires used for accessories connection; this way, in case of accidental detachment of a
conducting wire, dangerous voltage parts will not come into contact with safety low
voltage ones.
• The plastic case has an IP55 insulation; to connect flexible or rigid pipes, use
pipefittings having the same insulation level.
• Installation requires mechanical and electrical skills, therefore it shall be carried
out by qualified personnel only, who can issue the Compliance Certificate concerning
the whole installation (EEC Machine Directive 89/392, Annex IIA).
12