Programming The Operation Logic; Important - V2 ELETTRONICA PRGU433PP Manual De Instrucciones

PROGRAMMING THE OPERATION LOGIC

Several operation logic options are available for the control unit, by properly selecting the
position of the dipswitch positions on the board. The following table illustrates the
functions that pertain to every single dipswitch.
SWITCH FUNCTION
1 Pre-blinking (2 sec.)
2 Automatic closing
3 Start while opening
4 Start command logic
5 Slowing down
6 Photocell

IMPORTANT:

• The photocell can never be disabled during the closing.
• When using the automatic closing function (dip switch 2 ON) it is advisable to set
dip-switch 4 in OFF position. This prevents a START command to stop the
automation during the closing process.
POSITION DESCRIPTION
ON Active
OFF Non-active
ON
Active (after T.PAUS.)
OFF Non-active
ON Not received
OFF Received
ON Step-by-step function
START while opening command
OFF
activates closing
ON Active
OFF Non-active
ON Active also while opening
OFF Non-active while opening
15