Safety Notes - Chauvet COLORdash Batten Quad 6 Guía De Referencia Rápida

COLORdash™ Batten Quad 6 QRG
About this
Guide
Disclaimer

Safety Notes

Contact
What Is
Included
AC Power
Power Linking
AC Plug
Fuse
Replacement
The COLORdash™ Batten Quad 6 Quick Reference Guide (QRG) has
basic product information such as connection, mounting, menu options, and
DMX values. Download the User Manual from
for more details.
The information and specifications contained in this QRG are subject to
change without notice.
•
DO NOT open this product. It contains no user-serviceable parts.
•
DO NOT look at the light source when the product is on.
•
CAUTION: This product's housing may be hot when lights are
operating.
•
Mount this product in a location with adequate ventilation, at least 20
in (50 cm) from adjacent surfaces.
•
DO NOT leave any flammable material within 50 cm of this product
while operating or connected to power.
•
USE a safety cable when mounting this product overhead.
•
DO NOT operate this product outdoors or in any location where dust,
excessive heat, water, or humidity may affect it.
•
DO NOT operate this product if the housing, lenses, or cables appear
damaged.
•
DO NOT connect this product to a dimmer or rheostat.
•
ONLY connect this product to a grounded and protected circuit.
•
ONLY use the hanging/mounting bracket to carry this product.
•
In the event of a serious operating problem, stop using immediately.
•
The maximum ambient temperature is 104° F (40° C). Do not operate
this product at higher temperatures.
Outside the U.S., United Kingdom, or Ireland, contact your distributor to
request support or return a product. Visit
contact information.
•
COLORdash™ Batten Quad 6
•
Power Input Cord
•
Safety Cable
This product has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
You can link up to 17 COLORdash™ Batten Quad 6 products at 120 VAC
or 33 at 230 VAC. Never exceed this number. Power linking cords can be
purchased separately.
Connection
AC Live
AC Neutral
AC Ground
1. Disconnect this product from the power outlet.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing pulling out the installed fuse.
4. Remove the blown fuse from the safety cap and replace with a fuse of
the exact same type and rating.
5. Insert the fuse holder back in place and reconnect power.
•
•
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
2
www.chauvetlighting.com
www.chauvetlighting.com
Warranty Card
Quick Reference Guide
Screw Color
Brown Yellow/Brass
Blue
EN
for
Silver
Green