Installer System Test; System Status - Honeywell PRO TH3000 Serie Guia De Instalacion

Installer system test

After completing the installer setup, press the s button again to begin a sys-
tem test. Follow the procedure below to test the heating and cooling system.
System switch
1. Set SYSTEM switch to Heat.
t
2. Press to turn on and check systems (see table, below).
t
3. Press until systems turn off.
4. Set SYSTEM switch to Em Heat and repeat steps 2-3 above
5. Set SYSTEM switch to Cool and repeat steps 2-3 above.
ts
6. Press and hold
System test
Shaded areas below apply only to TH3210D.
10 Heating system
20 Emergency heat
30 Cooling system
70 Thermostat information
(for reference only)
CAUTION: EQUIPMENT DAMAGE HAZARD
Compressor protection is bypassed during testing. To prevent equipment damage,
avoid cycling the compressor quickly.
System test
number
to terminate test at any time.

System status

0 Heat and fan turn off.
1 Heat turns on.
2 Auxiliary heat turns on.
0 Heat and fan turn off.
1 Heat and fan turn on.
2 Auxiliary heat turns on.
0 Compressor and fan turn off.
1 Compressor and fan turn on.
71 Software revision number (major revisions)
72 Software revision number (minor revisions)
73 Configuration identification code (major)
74 Configuration identification code (minor)
75 Production configuration date code (week)
76 Production configuration date code (year)
System status
10
(TH3210D
7
PRO TH3000 series
0
T e st
MCR29403
only).
69-1929EFS—01