nurse 3BOARD Instrucciones página 15

GB
1 FITTING THE 3 WHEELS ONTO THE PLATFORM
A Fit the bolts into the three spaces for the wheel bearing on the back of the platform.
B Insert the wheel axles until they click into place. (Diagram 1)
• Once the wheel shave been fitted they are difficult to detach to prevent them from coming loose.
Warning: Fit the "bolts" to prevent the wheels from rubbing against the platform.
The adjustable parts have been solidly built to keep their shape.
In winter particularly, or in cold environments, the resin may harden making it difficult to in-
sert the wheels. If it is difficult to fit the wheels, use a hair dryer on the adjustable parts (the
wheel bearings) to warm them making it easier to insert the wheels.
• When the parts are warm, fit the wheels carefully to avoid burns.
• Do not expose the parts to a naked flame. There is a risk of burns or fire.
• If in doubt, get in touch with Babynurse
2
FITTING THE 2 ARMS ONTO THE PLATFORM
A For the arm hook to face outwards, the hole of the arm thread should pass through and fit
into the bolt of the axle of the arm (in the two spaces). (Diagram 2)
B Fit the bolt (small) into the arm axle bolt and gently tighten the wing nut (large), so that the
arm can turn once it is fitted. (Diagram 2)
Warning: Depending on the type of pushchair, when the arm hook has been fitted facing
outwards, it may knock against the pushchair preventing it from being installed correctly.
If this happens, swap the right arm for the left arm so that the arms are fitted facing in-
wards.
3 FITTING THE 2 JOINTS ONTO THE PUSHCHAIR
A Loosen the wing nut of the joint and pull the joint strap outwards. (Diagram 3/1)
B When the manual joint strap is rolled up around the support of the rear wheel of the push-
chair, insert the joint and fit the wing nut. (Diagram 3/2)
4 FITTING THE PLATFORM ONTO THE JOINTS
A Loosen all the wing nuts on the arms so that the angle can be changed easily.
B Fit the arm hooks on both sides into the slots of the joints fitted on the pushchair. (Diagram 4)
When the joint lever is pulled in the direction of the arrow, the slot opens.
ADJUSTING THE LENGTH OF THE ARMS AND THE HEIGHT OF THE JOINTS
5
A. While pressing the adjustment button, when it clicks, select the hole position and adjust
the length of the arm. (Diagram 5/1)
Warning: Adjust the length of the arm so that when the child is standing on the platform he
can hold onto the pushchair handles with both hands.
Note: Make sure that both arms are the same length. Check that the button is securely fas-
tened. If the button is not fastened, the platform loses stability and it can be very dangerous.
Warning: Check that the arms do not knock against the wheels.
INSTRUCCIONES
GEBRAUCHSANWEISUNG
INSTRUÇÕES
• INSTRUCTIONS
• INSTRUCTIONS
• ISTRUZIONI
15