GB
WARNING: When the platform is used tilted forwards it loses stability and it can be very dangerous.
It is important that the platform is fitted as shown in the diagram on the right, in other words, either
completely horizontal or tilting slightly backwards.
When the platform is not in use it can be hooked onto the pushchair and hung from it.
• Depending on the position and angle at which the platform has been installed it may not be possible
to hang it from the pushchair. In these cases, the platform should be detached and stored away.
• Note: when folding the pushchair, detach the board from the joints. However, sometimes when the pushchair
is folded it is not possible to detach the joints.
• Note: check that the platform is hung up properly.
• Note: when there is not a child in the pushchair and the platform is folded and hung up it can sometimes unba-
lance the pushchair and tip it over. Take care when folding the platform.
GEBRAUCHSANWEISUNG
1. Clip the strap hook into the hole in the front central part of the
platform.
2. Pass the strap around the pushchair handlebar, as shown in the
photograph on the left.
3. To lower the platform, take the hook out without pulling the strap.
• Adjusting the length of the strap.
• Adjust the strap to the appropriate length so it can be clipped on
correctly.
• Pass the strap behind through the lower space and then pass it
through the upper space.
• Leave the central serrated part clear.
• Fasten to the lower part of the lock with a simple click.
• Adjust the excess part of the strap and tighten it so it does not
come loose.
INSTRUCCIONES
•
INSTRUCTIONS
•
INSTRUCTIONS
INSTRUÇÕES
•
ISTRUZIONI
17