nurse 3BOARD Instrucciones página 16

GB
B When the platform is horizontal, adjust the height of the joints so that the 3 wheels are even
on the ground. (Diagram 5/2)
Note: Make sure that both joints are at the same height. If the joints are at different heights,
the platform loses stability and it can be very dangerous.
Warning: When the joints have been adjusted to a lower height, it is possible that the plat-
form can not be placed in the horizontal position and it is necessary to adjust the angle of the
joint. (See adjusting the angle of the arm joint in diagram 6 on the next page).
ADJUSTING THE ANGLE OF THE ARM JOINT.
6
The following instructions should be followed to adjust the angle of the arm joint so that the
3 wheels are even on the ground when the platform is in the horizontal position.
A Loosen the wing nut of the joint and adjust the angle of the arm joint so that the platform
is in the horizontal position. (Diagram 6)
B Once the angle of the joint has been adjusted, tighten the wing nut on the joint again.
• Warning: the two joints should be adjusted to the same angle.
LASTLY, TIGHTENING ALL THE SCREWS AND FASTENINGS.
7
A Once the length of the arm, the height of the joint and the angle of the arm joint have all
be adjusted, tighten all the wing nuts on the joints.
B Lastly, tightly fasten the wing nut of the arm thread on the back of the platform.
• Warning: The two arms should be adjusted to the same angle and the central part of the
pushchair and of the platform should be in the same position. (Diagram 7)
• Size (platform): 44 cm (width) x 16.5 cm
(height) x 22 cm (depth)
• Weight: 2.3 Kg. approx.
• Materials: (body) polypropylene,
(wheels) rubber, nylon, (connector
parts) steel, nylon
• Made in China
• Guarantee for product repairs
MAINTENANCE:
Keep the metal parts clean and dry to prevent them from rusting. Lubricate the mobile parts re-
gularly with silicone spray. Do not use oil or grease. Just use warm water and a mild detergent for
cleaning the plastic parts. For your safety and recommended maintenance it is advisable to take
the product to one of our official workshops to be inspected from time to time.
16
• Depending on the shape or type of push
chair support it may not be possible to in
stall the product.
• Width of the rear wheel support from 32.5
to 43 cm
• Measure the central part of the support.
• Diameter of the rear wheel support from
17 to 40 mm
• Width of the joint installation no less than
5 cm.