About This Manual - Powermatic PM-TJ Instrucciones De Funcionamiento Y Manual De Piezas

27. Use the right tool at the correct speed and feed
rate. Do not force a tool or attachment to do a
job for which it was not designed. The right tool
will do the job better and more safely.
28. Use recommended
accessories may be hazardous.
29. Maintain tools with care. Keep saw blades
sharp and clean for the best and safest
performance. Follow instructions for lubricating
and changing accessories.
30. Turn off table saw and disconnect from power,
before cleaning saw or tenoning jig. Use a
brush or compressed air to remove chips or
debris — do not use your hands.
Familiarize yourself with the following safety notices used in this manual:
This means that if precautions are not heeded, it may result in minor injury and/or
possible machine damage.
This means that if precautions are not heeded, it may result in serious injury or possibly
even death.

4.0 About this manual

This manual is provided by Powermatic covering the safe operation and maintenance procedures for a
Powermatic Model PM-TJ Tenoning Jig. This manual contains instructions on installation, safety precautions,
general operating procedures, maintenance instructions and parts breakdown. Your tenoning jig has been
designed and constructed to provide consistent, long-term operation if used in accordance with the instructions
as set forth in this document.
If there are questions or comments, please contact your local supplier or Powermatic. Powermatic can also be
reached at our web site: www.powermatic.com.
Retain this manual for future reference. If the tool transfers ownership, the manual should accompany it.
Read and understand the entire contents of this manual before attempting assembly or
operation! Failure to comply may cause serious injury!
accessories; improper
31. Never leave the machine running unattended.
Turn the power off and do not leave the
machine until it comes to a complete stop. Refer
to the table saw documentation for proper lock-
out procedures.
32. Remove loose items and unnecessary work
pieces from the area before starting the
machine.
33. This tenoning jig is designed for T-shaped miter
slots 3/4" wide x 3/8" deep. Do not modify this
jig to fit miter slots of other sizes.
5