decorflame MM521PCD-36FMC Manual Del Usuario página 5

Step 15: Place shelves [E] into the unit as shown in Fig. N.
Step 16: Attach 4 door hinges [R] to the left [K] and right [L] doors with 8 door hinge
screws [S]. Attach one door handle [Ta] to each door with door handle screws
[Tb]. See Fig. O.
Step 17: Attach left and right door [K and L] to panels F and g with 8 door hinge screws
[S]. See Fig. P.
Fig. N FrONt
Fig. O FrONt
Fig. p FrONt
Step 18: Attach cable hole cover [P] to panel b as shown in Fig. Q.
Step 19: Tighten all screws.
Step 20: Carefully move the assembled unit to the desired location. The fireplace mantel
should not be positioned in area exposed to direct sunlight.
OPERATION
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15 AMP/120 Volt outlet. If the cord does not reach, you
may use an extension cord rated for a minimum of 1875 wATTS. Once the fireplace insert
has been properly connected to a grounded electrical outlet, it is ready to operate.
OPERATION bY THE CONTROL PANEL
The controls are located behind the grill below the front glass and can be accessed by
pulling the grill from the top, forward and down.
warNiNG: DO NOt tOUcH. HOt SUrFacE at cENtEr OF Grill. HOlD lEFt Or riGHt SiDE
OF tHE Grill wHEN pUlliNG OUt.
0/i: Press this button for main power and flame effect. The indicator light will be on.
1250w: For heat function, press this switch while the 0/I switch is in the ON position. The
indicator light will be ON.
: To adjust the temperature to your individual requirements, turn the temperature
control dial to the right (clockwise) to increase the desired temperature and to
the left for lower temperature. This temperature control dial can only be used
while the 0/I switch and 1250w switches are in the ON position.
5
Fig. q FrONt