Hoover REWIND Manual De Instrucciones página 18

Keep your Rewind Running Properly: Cleaning Hose and Tools
CAUTION
To reduce the risk
of injury from moving parts
- Unplug
before servicing.
LUBRICATION
NOT REQUIRED.
The motor and brushroll are
equipped with bearings
which contain sufficient
lubrication
for their lifetime. The
addition of lubricant could
cause damage.
Do not add lubricant
to motor or brushroll.
15
NOTICE
A Thermal Protector has been designed into
your cleaner to protect it from overheating.
When the thermal protector activates the
cleaner will stop running.
If this happens proceed as follows:
1. Turn cleaner OFF and unplug it from
the electrical outlet.
2. Empty dirt cup.
3. Inspect the nozzle inlet, hose connector, hose,
dirt cup inlet, cyclonic filter, rinsable filter,
and HEPA filter. Clear obstructions if present.
4. When cleaner is unplugged and motor cools
for 30 minutes, the thermal protector will
deactivate and cleaning may continue.
If the thermal protector continues to activate
after following the above steps, your cleaner
needs servicing.
6 7
Clean out any
debris or hair from the
brushroll.
Replace bottom plate
and
replace screws
on either side.