Descargar Imprimir esta página

KTM Power Parts 83505183000 Manual De Instrucciones página 4

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

To ensure correct installation and operation of the exhaust system, read these instructions carefully.
The exhaust system can get extremely hot! Allow the ATV to cool before starting installation.
We advise you to leave the installation to a qualified service technician. Incorrect installation can result in a shorter service life of
the exhaust system and damage to the ATV.
1
4
A
6
4
7
1
2
4
3
5
6
Scope of supply, factory-supplied main silencer, ATV 83505183000:
1x main silencer
1x retaining bracket
1x Spark Arrestor device
Preparations
- Remove the series main silencer (see repair manual).
- Remove the flange adapters (1) and absorbing elements (2) of both fixing
loops of the original main silencer and fit them on the new main silencer.
Assembly
- Remove the screw (4).
- Position the retaining bracket (3) and fix it with the original screw (4).
NOTE:
Tighten the screw only hand-tight at first.
- Remove the nut (5) from position (A) and refit it on the previously fitted
retaining bracket (3).
- Push the main silencer on to the manifold and fix it with the original screws
(6).
NOTE:
Tighten the screw only hand-tight at first.
- Fit the original spring (7).
- Align the exhaust system and tighten screw (4) and screws (6).
M6 ->
10Nm
M8 ->
25Nm
When you first use the main silencer, keep the engine speed low for about
5 minutes to warm the main silencer evenly. Only this will ensure that the
rock wool will have full effect and keep the volume down to the required level!
Maintenance
Replace the rock wool of the main silencer every 15 hours.

Publicidad

loading