Progress Lighting AirPro P2556 Instrucciones De Instalación página 11

Installing the Light Kit
Fitter Assembly/ Glass
Bowl
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing the light kit.
THE GLASS IS FRAGILE, USE CARE
WHEN INSTALLING THE LIGHT KIT
AND THE GLASS SHADE.
1. Loosen but do not remove three of four
mounting screws from the fan motor
assembly; Remove one mounting screw.
(Figure 13)
2. Push the light kit fitter assembly up to
the fan motor assembly so that the three
loosened screw heads fit into the keyhole
slots. Turn the light kit fitter assembly
clockwise, tightened the screws. Re-install
the screw that was removed in step 1 and
tighten firmly. (Figure 13)
3. Place the glass bowl into the light kit fitter
assembly, aligning the three flat areas on
the top of the glass bowl with the three
raised dimples in the light kit pan. Turn
the glass bowl clockwise until it stops.
(Figure 14)
PERIODICALLY CHECK THE
SEATED FULLY CLOCKWISE IN THE LIGHT KIT
ASSEMBLY.
GLASS IS
Light Kit
Adaotor
Blue
Black
Light Kit
Assembly
Mounting
Screw (4)
Raised
Dimples
Glass
White
Molded
Adaptor Plugs
White
Figure 13
Light Kit
Assembly
Flat Area
Figure 14
8.