Siemens SIMATIC S7-1500 Información Del Producto página 20

Result
The CPU volume is created automatically as part of the installation process.
The graphic below provides an overview of how the partition is allocated on your PC after the installation of the CPU.
Image 2 Allocation of the data storage media after the installation of the CPU
Manual creation of the CPU volume
If the CPU volume cannot be created automatically, you have the following options available:
● The installation process outputs a message that provides you the opportunity to manually perform the partitioning.
Alternatively, you can cancel the installation process at any time.
● You must remove files from the D:\\ partition, since there is insufficient storage space available to perform the partitioning
of the hard drive.
● You must manually decrypt the D:\\ partition
● Rename an existing partition on data storage medium 0 to partition D:\\. The operating system must not be installed on
this partition.
After this, carry out the setup again.
Limited support
HART modules with PROFIBUS
The CPU does not support HART modules at the PROFIBUS interface.
Diagnostics repeater
The CPU 1507S does not support the diagnostics repeater or the DP_TOPOL block associated with it.
IWLAN/PB-Link
The CPU V1.8 does not support the "IWLAN/PB-Link" functionality.
PLCSIM
PLCSIM cannot simulate any SIMATIC Software Controller projects.
20
Additional Information on CPU 1505S/CPU 1507S
A5E35341137-AE, 03/2016