Sauder Hanover Closets 413120 Manual Del Usuario página 10

6 6
M
Carefully turn your unit over onto the RIGHT END (A). Lay the BACK (F) over your unit.
Make equal margins along all four edges of the BACK (F). Push on opposite corners of your unit if needed to make it "square".
Fasten the BACK (F) to your unit using the NAILS (U).
Go to the next step if this unit will be stacked on another unit. If this unit will sit on the floor continue on with this step.
Use a hammer to drive a PROPEL NUT (Q) into the holes in ENDS (A and B) and RIGHT BACK (C). Now, turn an ADJUSTABLE
GLIDE (M) clockwise completely into each PROPEL NUT.
Go to step 8 if this unit sits on the floor. Continue on with the next step if this unit will be stacked.
Page 10
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
C
A
Q
Fasten the PROPEL NUT (Q) and
ADJUSTABLE GLIDE (M) only
if this unit sits on the fl oor. Go to
step 7 if this unit is stacked.
www.sauder.com/services
F
B
U
NAIL
(29 used in this step)
413120