Sauder Hanover Closets 413120 Manual Del Usuario página 12

8 8
413120 stacked
corner unit
Use ANCHOR only if you can
not locate a stud in the wall.
L
K
T
413120
corner unit
NOTE: Be sure the unit is level. If it is not, make adjustments by turning the ADJUSTABLE GLIDES counter-clockwise to lower the
unit and clockwise to raise the unit.
Locate and mark the wall stud locations on your wall. If you cannot locate a stud in your wall, skip over the next paragraph to the
WALL ANCHOR installation.
Use a BLACK 9/16" LARGE HEAD SCREW (T) into the TOP (D) of the unit and a BLACK 1-7/8" PAN HEAD SCREW (S) into the
stud in your wall. Be sure to allow the distance of any baseboards in your closet. There are no holes provided in the unit to attach the
SAFETY BRACKET (K). Use a little extra force while turning the BLACK 9/16" LARGE HEAD SCREW (T).
WALL ANCHOR INSTALLATION
While holding the SAFETY BRACKET (K) against the wall directly above the unit, mark the location through the hole in the
SAFETY BRACKET onto the wall to drill for the WALL ANCHOR (L).
On the marked location, drill a 1/4" hole into the wall. Turn the WALL ANCHOR (L) into the hole until it is flush. Next position the
SAFETY BRACKET over the WALL ANCHOR and turn the BLACK 1-7/8" FLAT HEAD SCREW (S) into the WALL ANCHOR.
Be sure to allow the distance of any baseboards in your closet. There are no holes provided in the top of the unit. Use a little extra
force while turning the BLACK 9/16" LARGE HEAD SCREW (T) into the TOP (D).
Repeat this step to fasten the remaining SAFETY BRACKETS along the TOP of the upper unit and ENDS of the lower unit.
Page 12
S
www.sauder.com/services
L
D
Use ANCHOR only if you can
not locate a stud in the wall.
T
K
S
413120
corner unit
D
413120