THERMEx PRO LINK II Serie Instrucciones página 68

68 THERMEX PRO LINK II
CONNECTING THE RECEIVER
The receiver must be connected to the external ventilation system. The receiver is connected in accordance with the diagram:
Dipswitch
The red LED will light up when the power is connected.
INSTALLING THE TRANSCEIVER ON VERTICAL MODELS, VICHY AND ASTON
On vertical models, Vichy and Aston, the transceiver is mounted directly on the circuit board box inside the hood. The transceiver is installed by
following the steps shown below:
1
Open the hood and take out the filter.
4
Remove the connector from the control pan-
el of the circuit board.
Diode
L N
Fuse
Pair button
230 V in
2
The circuit board is located inside the hood be-
hind the filters.
5
Mount the connector from the transceiver on the
hood's circuit board and place the plastic cap.
NO NC
COMM
Relay 2
N F1 F2
COMM
230 V out
for valve
3
Remove the plastic cap from the connector on the
circuit board box. This easiest way to do this is to use
a screwdriver or similar tool to gently coax the cap off.
6
Mount the connector from the control panel
on the transceiver.
M 536991501911122018
NO NC
Relay 1