Cleaning The Filter Unit - Ubbink Robotclean 3 Manual Del Usuario

1 Pool Robotclean 3 Operating Manual and Parts List
Note
1. You can also stick the two foam blocks on top of each cover without opening the cover.
2. Press both foam blocks down well onto the covers. Please wait 24 hours before using the cleaner again.
MAINTENANCE
Use conventional care products for cleaning. Do not use solvent-containing or abrasive cleaning agents, hard sponges, brushes, etc.

Cleaning the filter unit


CLEAN THE FILTER UNIT AFTER EACH CLEANING CYCLE
Figure 1
Figure 3
- Slide the clips on the top cover into the position to open the cover (see Figure 1)
- Open both sides of the cover (see Figure 2).
- Remove both filter baskets (see Figure 3).
- Clean both filter baskets (see Figure 4).
- Insert the cleaned filter baskets (see Figure 5). Pay attention to the correct installation position.
- Close both covers and slide the clips into the locking position (see Figure 6)
Changing the PVC lamellar brushes
Note: The pool cleaner is equipped with PVC lamellar brushes for pools with PVC film. To clean tiled pools, please replace the PVC lamellar brushes with PVA foam rollers, which are
available to order as spare parts.
1. Undo the screw connection on the right and left of the lamellar brushes and take the PVC lamellar brushes off. See illustrations
Manual RobotClean 3 2020.indd 4 Manual RobotClean 3 2020.indd 4
Figure 4
Figure 2
Figure 5 Figure 6
26.10.20 12:20 26.10.20 12:20