General; Inspection And Placement - ESAB ESP-150 Manual De Instrucciones

Ocultar thumbs Ver también para ESP-150:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 69
SecTION 3
cauTION
Precautionary measures should be taken
to provide maximum protection against
electrical shock. be sure that all power is
off by opening the line (wall) disconnect
switch and unplug the power cord to the
unit when primary electrical connections
are made to the power supply.
elecTRIc ShOcK caN KIll! Precaution-
ary measures should be taken to provide
maximum protection against electric
shock. be sure that all power is off by
opening the line (wall) disconnect switch
and by unplugging the power cord to the
unit when connections are made inside of
the power source.
This product is intended for industrial use. In a domestic environment
this product maycause radio interference. It is the user's responsibility
to take adequate precautions.
3.0

geNeRal

Proper installation can contribute materially to satisfactory and trouble-free
operation of the cutting outfit . Each step in this section should be studied
carefully and followed as closely as possible .
3.1

INSPecTION aND PlaceMeNT

1 . Having removed the shipping container, and before removing the skid,
inspect for evidence of concealed damage which may not have been
apparent upon receipt of the unit . Notify the carrier of any defects or
damage at once .
2 . Check the container for any loose parts . Check air passages on rear panel
of cabinet for any packing materials that may obstruct air flow through
the power supply .
The ESP-150 Power Source is equipped with one lifting eye that enables
hoisting the unit . Be sure the lifting device has adequate capacity to lift
the unit safely . Refer to the SPECIFICATIONS for the unit weight .
3 . Mount the components of the TR-21 Truck Kit to the unit as covered by
Form F-14-413 packed with the truck kit .
4 . The machine components are maintained at proper operating tempera-
tures by forced air which is drawn through the front panel louvers and
holes in the base and out the rear panel by a heavy-duty fan . Locate this
machine in an open area where air can circulate freely through the open-
ings . Leave at least two feet of clearance between the unit and wall or
other obstruction . The area around the unit should be relatively free of
dust, fumes and excessive heat . (Installing or placing any type of filtering
device will restrict the volume of intake air, thereby subjecting the power
source internal components to overheating. Use of any type of filter device
voids the warranty.)
5 . A source of clean, dry air that supplies a minimum of 250cfh (7 .08 M
110 psig) is required for the cutting operation . The air supply should not
exceed 150psig (10 .3 bars) - maximum inlet pressure rating of the filter
regulator supplied with the package .
17
INSTallaTION
H at
3

Publicidad

Tabla de contenido
loading

Tabla de contenido