Maintenance / Service; Declaration Of Conformity - Skil 2536 Manual Del Usuario

MAINTENANCE / SERVICE

• Keep tool and charger clean
! unplug charger from power
source before cleaning
• If the tool/charger should fail despite
the care taken in manufacturing and
testing procedures, repair should be
carried out by an after-sales service
centre for SKIL power tools
- send the tool or charger
undismantled together with proof
of purchase to your dealer or the
nearest SKIL service station
(addresses as well as the service
diagram of the tool are listed on
www.skileurope.com)
ENVIRONMENT
• Do not dispose of electric tools,
accessories and packaging
together with household waste
material (only for EU countries)
- in observance of European
Directive 2002/96/EC on waste of
electric and electronic equipment
and its implementation in
accordance with national law,
electric tools that have reached the
end of their life must be collected
separately and returned to an
environmentally compatible
recycling facility
- symbol 8 will remind you of this
when the need for disposing
occurs
! remove the batteries before
disposal of the tool
• Removing/disposing of batteries *
! only remove the batteries if they
are completely empty
- protect battery terminals with
heavy tape to prevent short-circuit
- dispose of the batteries at an
official collection point for batteries
! batteries may explode when
disposed of in fire, so do not
burn battery for any reason
DECLARATION OF
CONFORMITY
• We declare under our sole
responsibility that this product is in
conformity with the following
standards or standardized documents:
EN 60335, EN 60745, EN 55014, in
accordance with the provisions of the
directives 2006/95/EC, 2004/108/EC,
2006/42/EC
• Technical file at: SKIL Europe BV
(PT-SEU/PJE), 4825 BD Breda, NL
Arno van der Kloot
Vice President
Operations & Engineering
SKIL Europe BV, 4825 BD Breda, NL
30.06.2011
NOISE/VIBRATION
• Measured in accordance with
EN 60745 the sound pressure level of
this tool is <70 dB(A) (standard
deviation: 3 dB) and the vibration ✱ m/
s² (hand-arm method; uncertainty K =
1.5 m/s²)
✱ when screwdriving <2.5 m/s²
• The vibration emission level has been
measured in accordance with a
standardised test given in EN 60745; it
may be used to compare one tool with
another and as a preliminary
assessment of exposure to vibration
when using the tool for the
applications mentioned
- using the tool for different
applications, or with different or
poorly maintainted accessories,
may significantly increase the
exposure level
- the times when the tool is switched
off or when it is running but not
actually doing the job, may
significantly reduce the exposure
level
! protect yourself against the
effects of vibration by
maintaining the tool and its
accessories, keeping your
hands warm, and organizing
your work patterns
Tournevis sans fil
INTRODUCTION
• Cet outil avec rotation à droite/gauche
est conçu pour le vissage et le
perçage préalable au bois
9
Jan Trommelen
Approval Manager
2536