Cequent Performance Products 24951 Instrucciones De Instalación página 4

1a. Fascia removal – Using a 7mm socket, remove (4) screws from
bottom of fascia and (2) screws located on rear of fascia near
license plate area.
1d. Remove taillights - open trunk. Using a flat screw driver, open the
plastic caps covering the screws holding the taillights. Using a T15
torx bit, remove (2) screws from each taillight and gently remove the
taillights by pulling rearward. Disconnect the wiring harness and set
taillights aside.
©2016 Cequent™ Performance Products, Inc. -
Printed in Mexico
1b. Fascia removal – Using a T15 torx bit, remove (3) screws from
wheel well, each side.
1c. Using a 7mm socket, remove (1) screw located vertically in the
upper area of wheel well behind the wheel well liner, both sides.
1e. Using a plastic trim panel tool, remove the plastic fascia starting at
the outer edges near the wheel wells and gently pulling the fascia.
Disconnect the wiring harness from fascia.
Sheet 4 of 21 24951NP 9-27-16 Rev. A