Basic Safety Instructions - Siemens SITRANS TSinsert Manual Del Usuario

4 Installing
4.1

Basic safety instructions

WARNING
Unsuitable cables, cable glands and/or plugs
Danger of explosion in hazardous areas.
Use only cable glands/plugs that comply with the requirements for the relevant type of protection.
•
Tighten the cable glands in accordance with the torques specified in Construction (Page 26).
•
Close unused cable inlets for the electrical connections.
•
When replacing cable glands use only cable glands of the same type.
•
After installation check that the cables are seated firmly.
•
See also
Technical data (Page 23)
CAUTION
Hot surfaces resulting from hot process media
Danger of burns resulting from surface temperatures above 70 °C (155 °F).
Take appropriate protective measures, for example contact protection.
•
Make sure that protective measures do not cause the maximum permissible ambient temperature to be exceeded.
•
Refer to the information in Technical data (Page 23).
WARNING
Unsuitable connecting parts
Danger of injury or poisoning.
In case of improper mounting hot, toxic and corrosive process media could be released at the connections.
Ensure that connecting parts (such as flange gaskets and bolts) are suitable for connection and process media.
•
See also
Technical data (Page 23)
4.1.1 Exceeded maximum permissible operating pressure
WARNING
Exceeded maximum permissible operating pressure
Danger of injury or poisoning.
The maximum permissible operating pressure depends on the device version, pressure limit and temperature rating. The
device can be damaged if the operating pressure is exceeded. Hot, toxic and corrosive process media could be released.
Ensure that maximum permissible operating pressure of the device is not exceeded. Refer to the information on the
nameplate and/or in Auto-Hotspot.
SITRANS TSinsert/TS100/TS200/TS300/TS500 (7MC71.. 7MC72.. 7MC80.. 7MC75.. 7MC65.. 7MC55..)
A5E03920348-AB, 03/2016
11