Tyre Mounting - TECO UPH Manual De Instrucciones

The PAX System is made up of the following parts (fig. 30):
1. Special PAX System profile rim (T) (for full width contact or clipé rest)
2. Rest (S) (for full width or clipé rest)
3. PAX tyre (R)
4. Pressure control sensor (T1)
- Spread the inner part of the tyre with the special PAX System Gel of the mechanical
support fig. 31
- Lubricate the beads of the PAX tyre (R) and the surface of the support (S) that will
come into contact with the rim with standard lubricant for vehicle wheel mounting fig. 32
IMPORTANT
When lubricating the tyre interior with the special PAX System Gel of the mechani-
cal support, be careful not to touch the beads with that gel, since the beads are to be
lubricated with standard tyre lubricant
- Insert the Support (S) inside the tyre (R) fig. 33
- Use the special levers fig. 34
WARNING
Make sure the orientation of the rest (S) is correct when introducing it into the tyre, as
described in Fig. 35 for standard, and in fig.35a for Clipé.
- Lubricate the bead housings on the rim (areas indicated with the letter T in fig. 36)
- Introduce the tyre-rest assembly on the rim fig. 36
(Procedure for Pax System with full-width rest)
- Place the selector (E) on position 1 fig. 37
- If not present, mount the cylindrical roller on the arm fig.37a
- Move the arm axially until the cylindrical roller is brought into position, flush with the
rim fig. 37
- Press the roller onto the bead of the tyre, and at the same time rotate the turntable
until the rest (S) is fully inserted in the rim (T) fig. 37
- At completion lift the roller off the tyre.
(Procedure for Pax System with clipé rest)
- Mount the double roller tool (J) in fig. 38
- Move the arm axially until the roller with the greater diameter is brought in position,
flush with the rim
- Remove the tyre bead, bring the roller down to the surface of the rest while keeping
the bead behind the special claw on the double roller tool fig.39
- Rotate the turntable until the rest (S) is fully inserted in the rim (T). At completion lift
the roller off the tyre.
UPH operator's manual

TYRE MOUNTING

Tyre support mounting
Mounting of the support on the rim
Mounting the rest on the rim
GB
27