TECO UPH Manual De Instrucciones página 31

1) Clamp the rim on the table and mount the rise bead as described in the Instruction
manual of the tyre changer.
WARNING
The positioning and the removal of the operating arm of the tyre changer from
the edge of the rim can be carried on only after having brought UPH arms out-
wards in non-working position.
2) Position the bead pressing device (B1, Fig. 8) near the mount/demount tool (at
about 3-4 cm .
Lower it until the bead is level with the centre well.
WARNING
Bringing the bead-pressing tool against the tyre creates a danger: the opera-
tor's hands could be crushed between the tool and the rim.
Be careful and keep your hands far from the rim.
3) As the turntable turns the bead pressing tool will revolve with the tyre and keep the
bead in the well. The second bead will thus be mounted on the rim without any
effort nor danger to the operator or without risking to damage the tyre (Fig. 49).
4) After fitting has been completed by means of the control lever (G, Fig. 8) , lift the
bead pressing tool and bring the arm (A1, Fig. 8) in non-working position.
UPH operator's manual
MOUNTING A TIRE
GB
31