Identification Of Parts; Installation - Anova BE1300P Instrucciones - Manual Usuario

4. Identification of parts

1. Pressure switch
2. Manometer
3. Drain plug
4. Tank
5. Flexible hose
6. Elbow connector
7. Pump body
8. Filler cap
9. Diffuser
10. Driving
11. Mechanical seal

5. Installation

This product must be installed and maintained by a qualified person competent in handling
the máquina.La installation and operation must be in accordance with local regulations and
operating criteria reconocidos.Instale the pipes
correctly according to requirements these instructions
and protect them from freezing.
1. For the installation of the pump, the inlet tube
should be as short as possible with fewer turns. The
pump must be installed in ventilated, dry
environment. It can be installed on the outside,
provided you have adequate cover to avoid rain and
wind.
2. For use of the pipe, the valves must be installed in
12. O-ring
13. Cover
14. Motor flange
15. Fan
16. Engine cover
17. endplate
18. Rotor
19. stator
20. Cover Switch
21. Leadframe
22. faceplate
Max. temperature: 40°C
Min temperatura:
- -
4ºC