Troubleshooting - Anova BE1300P Instrucciones - Manual Usuario

7. Troubleshooting

Check the pump only after the cut is off and the power supply.
issue
The engine can not be
started.
The motor is running but
no water is discharged.
underpressure
probable cause
Single phase power (three-phase
electric motor): a. poor connection of
the power switch;
b. the fuse is blown;
c. loose power cable;
d. phase failure of the cable
The condenser is burned
The rotary shaft and bearing are
stuck.
The impeller is jammed.
Motor wiring is damaged.
Line pressure above the set pressure
of the pressure switch (automatic
pump).
Incorrect direction of rotation of the
pump.
The pump is not completely filled with
water.
The impeller is damaged.
Drain suction pipe.
The water level is very low.
Freezing caused by water
accumulated in the pipe or the
chamber.
Wrong type of pump.
The inlet pipe is too long or too
curved, the diameter of the pipe is
not appropriate.
to. contact repair or replace the circuit
breaker switch;
b. replace the safety fuse;
c. check and tighten the power connector;
d. repair or replace cables.
Replace with the same type of capacitor
(send maintenance point for repair).
Replace the bearing (send maintenance point
for repair).
Turn the rotating shaft of the fan terminal with
a screwdriver to rotate freely allow or
disassemble the pump body to remove
debris.
Replace winding (send maintenance point for
repair).
Increase pressure cutting power pressure
switch, ie turn the screw nut variable in the
"+" direction one or two turns, or replace it
with a more suitable product.
Invest biphasic motor cables (three phase
motor).
Refill the pump with water.
Replace the impeller (send it to the point of
maintenance for repair).
Check sealing various pipe joints input.
Adjust the height of the pump installation.
Start the pump after the ice melts.
Select the appropriate pump.
Apply the pipe diameter and shorten
stipulated inlet pipe.
- -
Required action