Installation Instructions - CLiC-iT C-ZAM Instrucciones De Uso

Procedure for fitting C-ZAM , C-ZAM V2 Rope and C-ZAM L / L+ rings
Step 1
C-ZAM
C-ZAM
V2 Rope
C-ZAM
L / L+
Materiel
provided :
C-ZAM et
C-ZAM V2 Rope
- 2 C-ZAM half
rings
- 4 screws
C-ZAM L / L+
- 3 C-ZAM half
rings
- 4 screws
Installation on 10 diameter
Route in/out system
Sheathed 12 mm diameter
1/2 inch diameter (12.7 mm)
Assembly on 12 mm diameter
loop
Step 2
Position both half-
rings on your cable or
your rope

Installation instructions

Wrap Chatterton scotch
tape around the 10
diameter cable 3 times in
order to obtain a diameter
of 12
Assembly described below
Assembly described below
Assembly described below
Step 3
Screw crosswise
using a 5mm BTR
key (C-ZAM and C-
ZAM V2 Rope) or a
TORX M4 (C-ZAM L
and C-ZAM L+)
without tightening
all the way
Step 4
Finish screwing the 4
screws crosswise,
tightening can be
done using a screw
gun (be careful to
limit the torque)