CLiC-iT C-ZAM Instrucciones De Uso página 48

Check before use
With each use, the state of the swivel must be
rigorously and visually inspected by a trained and
competent person.
Use
The CLiC-iT C8++ swivel is a system that allows free
rotation removing the twist and may be associated
with personal protective equipment. This product is
intended for occasional openings.
This swivel can be mounted on personal protective
equipment for use on Via Ferrata and acrobatic course
only. These activities are dangerous and could result in
serious and even fatal injuries. It is not necessary for
this product to be personally aimed at a single user in
the event of a collective donation.
Carefully read and understand these instructions.
This product should only be used by trained or
competent people or, where appropriate, under the
direct supervision of a trained and competent person.
It is your responsibility to learn about the appropriate
techniques and safety measures.
In any case, this equipment must not be used beyond
its limits or in any other situation for which it is not
designed. If other components are used with this
product, their compatibility must also be checked.
Equipping yourself with a personal protective system
against falls (PPE) does not justify freely exposing
yourself to fatal risks.
The manufacturer declines all responsibility in the
event of misuse or incorrect application of the product
or for swivels modified or repaired by third parties not
authorised by the manufacturer. These repairs must be
carried out according to the operating method
provided by the manufacturer.
Verify that the use of this equipment is compatible with
other systems conforming to the European standards,
such as for example, regarding sports equipment:
EN566 sling, EN892
connectors.
Verify that the system is correctly assembled and that
the various elements work without interfering.
When using several articles be careful to make sure
that the safety function of one of the articles is not
affected by the safety function of another article or
doesn't interfere with it.
Storage and transport
Remove the swivel from its packaging and store it in a
dry, clean and ventilated spot. The swivel should not
come into contact with corrosive chemical substances,
solvents and heat sources. There are no other special
precautions to be taken during transport.
dynamic ropes, EN12275
Maintenance
Always ensure the swivel is in good condition before
and during use. Replace the swivel in case of doubts
about its condition, if it shows signs of wear or
corrosion. Avoid contact with heat sources, corrosive
substances. In case of contact wash immediately with
clean water (between 15 and 20°C) then dry with a
cloth.
Verify the totality of the swivel and its proper rotation. If
any doubts persist, please contact SARL DEHONDT. All
maintenance and inspection of the swivel must be
reported on the following inspection sheet. No
lubrication is necessary under normal conditions of use.
Verify the legibility of the product's markings at each
periodic inspection.
General operating instructions
Before each use, verify, inspect and ensure the
compliance of the CLiC-IT C8++ swivel. In case of
doubt, replace it. This swivel was examined for use in
standard weather conditions (-30°C/+50°C). Replace the
product if it was subject to a significant fall, even if it
doesn't show any faulty visual or functional aspects.
Effect of aging
All products are subject to aging, due to use, storage.
Aging can reduce the effectiveness of the product.The
aging of the product depends directly on the use of the
product, the frequency of use, the competence of the
user, the environment during use. In addition, changing
standards can make the product obsolete.
Component detail
Piece
Piece
number
1 DAS133 Axis
2 DAS135 Rivet
3 DAS136 Closing axis
4 Locking screw
5 DAS138 Openable Ring
6 DAS139 Closing finger
7 Fluted pin
*Stain = Stainless steel
Material Qty
Stain* 1,4404 1
Stain* 1,4301 2
Stain* 1,4301 2
Stain* 1,4301 1
Stain* 1,4462 2
Stain* 1,4462 2
Stain* 1,4301 1