Clean Washer; Stay Fresh - Sears Kenmore 796.4128 31 Serie Manual De Uso

SPECIAL FUNCTIONS
CONTR OL LOCK
Extra Rinse | Use this option to disable the controls.
Coo,_olLo0ki_ J The washer can only be locked during a
cycle. This feature can prevent children
from changing cycles or operating the machine. Once
set, the controls remain locked and must be turned OFF
before the controls can be used again. Once the washer
has shut off, the power button wilt allow the machine
to be turned ON, but the controls will still be locked.
When the controls are locked, the Control Lock LED wilt
illuminate and "CL" will display alternately with the
estimated time remaining.
To activate the control lock, press and hold the EXTRA RINSE
button for five seconds.
CLEAN WASHER
Clean | Detergent residue can build up in the wash
Stay F_esh J drum over time and can lead to a mildewy
or musty smell. The Clean Washer cycle is
specially designed to remove this buildup using bleach or
another cleaner designed specifically for cleaning front load
washers. Run the Clean Washer cycle once a month, or more
often under heavy use conditions or if odor is present. See
complete instructions in the CARE AND CLEANING section.
@
O
Turn ON the washer and press the CLEAN WASHER
button. Selecting any other cycle after Clean
Washer has been selected will cancel the Clean
Washer cycle.
Fill the bleach dispenser to the MAX line with liquid
chlorine bleach. Do not overfill the bleach dispenser.
Overfilling will cause the bleach to dispense
immediately.
NOTE: For other drum cleaning products, follow
the cleaner manufacturer's instructions and
recommendations. For powdered cleaning products,
add the cleaner to the main wash compartment of
the dispenser drawer. Place tablet cleaners directly
into the drum.
Press the START/PAUSE button to start the cycle.
After the cycle has ended, secure the door slightly
ajar with the door magnet.
This will
promote air
circulation and allow the interior of the machine to
dry. To use this feature, close the door just until it
contacts the door magnet.
NOTE: Do NOT use this cycte with clothes, and do
NOT add detergent or fabric softenen
MY CYCLE
1 Cycle 1 MY CYCLE allows you to store a
My
customized wash cycle for future use. It
J
allows you to save favorite temperature,
spin speed, soil level, and other options for a cycle, and
then recall them at the touch of a button.
NOTE: You can only save a setting for one cycle at a
time. Pressing and holding the MY CYCLE button will
overwrite any previously saved cycle.
To save a MY CYCLE:
O Press the POWER button to turn on the washer.
O urn the cycle selector knob to select the desired
cycle.
Press the CYCLE MODIFIER button to change the
desired setting.
Press the CYCLE OPTION button to add the desired
options.
O Press and hold the MY CYCLE button.
To recall a MY CYCLE:
O Press the POWER button to turn on the washer.
0
Press the MY CYCLE button. The stored settings will
be displayed.
O Press the START/PAUSE button to start the cycle.
NOTE: MY CYCLE can be adjusted the same as any
other cycle. However, once any other button is pressed,
the LED will
turn o_ indicating that the settings are no
longer those of your saved cycle.
AUTO SOAK
t_;i":_/_ " /_ _i| Use the Auto Soak option to presoak
A_toSook j garments to help remove difficult spots
or stains on fabric. This option provides
a 30 minute presoak prior to the start of the selected
cycle. At the end of the presoak time, the selected cycle
will use the same water.
To use the AUTO SOAK feature, press and hold the
STEAM TREAT button for five seconds.
STAY FRESH
Clean
Washer] The Stay Fresh option helps keep
Stay Fresh J wrinkles from setting in clothes.
To select the Stay Fresh option,
press and hold the CLEAN WASHER button for
approximately five seconds.
23