Sears Kenmore 796.4128 31 Serie Manual De Uso página 30

Lavadora automatica de carga frontal
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BEFORE CALLING
FOR SERVICE
Staining
Washer will not
turn ON
Door wlll
not un-
lock
when cycle is
stopped or
paused
Wash cycle time is
longer
than usual
Musty or mildewy
odor in washer
Wrinkling
Bleach or softener dispensed
too soon.
Bleach or softener was added directly to the
wash load in the drum.
Washer was not unloaded promptly.
Clothes were not properly sorted
Power cord is not properly
plugged
in.
House fuse is blown, circuit breaker has
tripped,
or power outage
has occurred.
House fuse is blown, circuit breaker has
tripped,
due to multiple appliances
on
one outlet.
Interior temperature
of washer is too high.
Water level in washer is too high.
The washer automatically
adjusts the
wash time for the amount of laundry,
water pressure, water heating time and
other operating
conditions.
Incorrect or too much detergent
has
been used.
Inside of drum was not cleaned
properly.
Washer not unloaded
promptly.
Washer overloaded.
Hot and cold water inlet hoses are
reversed.
Dispenser compartment is overfilled causing bleach or
softener to dispense immediately.
Dispenser drawer closed too quickly causing bleach or
softener to dispense immediately.
Laundry chemicals must be loaded into the dispenser.
Always remove items from the washer as soon as pos-
sible after the cycle iscomplete.
Always wash dark colors separately from light colors
and whites to prevent discoloration.
Never wash heavily soiled items with lightly soiled
items.
Make sure that the plug is plugged
securely into a
grounded,
3-prong,
120-VAC, 60-Hz outlet.
Reset circuit breaker or replace fuse. Do not
increase fuse capacity.
If the problem
is a circuit
overload,
have it corrected
by a qualifled
electri-
cian.
Reset circuit breaker or replace fuse. If more than
one appliance
is connected
to the outlet, call an
electrician
to have an additional
circuit installed.
The washer door has a safety feature to prevent
personal injury. For example, if the washer is
paused during the hot wash stage of a cycle, the
interior temperature
of the drum will be very hot,
so the door will not unlock. This is normal.
Allow the washer to cool until the DOOR LOCI(
indicator
turns OFF on the display.
To drain the water, press POWER, then press the
SPIN SPEED button without selecting a cycle.
This is normal. The washer adjusts cycle time
automatically
to provide
optimal
results for the
selected
cycle. The time remaining
shown in the
display
is only an estimate.
Actual
time may vary.
Use only High-Efficiency
(HE) detergent
in accordance
with the manufacturer's
instructions.
Run the CLEAN WASHER cycle O regularly.
Be sure to
wipe around and under the door seal frequently.
See
Care and Cleaning
of the Interior.
Clean around
door seal/glass
to prevent odor.
Always
remove items from the washer as soon as the
cycle is complete.
When washing
large loads, do not overstuff: the drum.
The washer can be fully loaded,
but the drum should
not be tightly
packed
and the door should close easily.
Hot water
rinse can set wrinkles
in garments.
Check the inlet hose connections.
3O

Publicidad

Tabla de contenido
loading

Tabla de contenido