Uline H-1096 Guia De Inicio Rapido página 5

USING THE FULL COUNTING FUNCTION
1. Press the zero key.
2. Place a known number of pieces on the pan.
3. Enter the number of pieces through the scale
keyboard.
4. Press the count key.
5. Wait for the "OK" symbol.
6. Add pieces until you reach the desired piece count.
7. Wait for the "OK" symbol, then read the display.
NOTE: The scale may request that more
pieces be added after the initial sampling if a
minimum accuracy and/or minimum sample
size requirements have been preset.
COUNTING WITH A CONTAINER
1. Press the zero key.
2. Place the container on the pan.
3. Press the tare key or zero key. (If the tare weight is
known, a full container may be placed on the pan
in step #2. In this case, enter the tare weight through
the keyboard and then press the tare key.)
4. Wait for the "OK" symbol. Then press the sample size key.
5. The scale display will say "Add 10. PC". (The sample
size requirement can be increased by pressing the
sample size key repeatedly. The predetermined
sample sizes are: 10, 25, 50 and 100 pcs.
This sequence of predetermined sample sizes will
repeat itself as the sample size key is pressed.)
WARNING! Scale can only be accurately
calibrated using standard calibrated scale
weights. Using non-calibrated weights may result
in inaccurate scale calibration. Nothing should
be on the scale. The scale should be level.
1. Turn on the scale. Press the reset key.
2. Press the units key until the scale displays the units of
the known weight (i.e., grams, oz., lbs., etc.)
PAGE 5 OF 15
OPERATION CONTINUED
6. When you reach the desired sample size, place the
7.
8. Wait for the "OK" symbol. Then add pieces until you
9. Wait for the "OK" symbol. Then read the display. The
DISPLAYING GROSS WEIGHT
DURING COUNTING
1.
2. Press count to return to the counting mode.
COUNTING WITH A KNOWN
AVERAGE PIECE-WEIGHT
1.
2. Place the pieces on the pan.
3. Enter the known average piece weight through the
4. Press the a.p.w. key.
5. Wait for the "OK" symbol. Then read the display. The
CALIBRATION
3. Place the known weight (standard scale weight) on
4. Use the numeric keypad to enter the value of the
5. Press the setup/cal key.
1-800-295-5510
uline.com
requested number of pieces in the container.
Press the count key.
reach the desired piece count.
scale will read the total number of pieces you have
placed in the container.
NOTE: You may recall the tare weight by
pressing display, tare, but only if it was stored
in step #3 by using the tare key and not the
zero key.
Press the gross key to display the gross weight.
Press the zero key.
keyboard.
scale now reads the number of pieces on the pan.
NOTE: Before you enter an average piece
weight, make sure your scale is reading in the
the weighing pan.
NOTE: For maximum accuracy, the weight used
should be as close as possible to the scale
capacity.
known weight.
0521 IH-1096