Connecting To Power; Keyboard Functions - Uline H-1096 Guia De Inicio Rapido

CONNECTING TO POWER

NOTE: When your scale is first powered on, it
automatically runs through a 6-second display
test. The scale next displays "C nnn g" (where
nnn equals the full scale capacity in grams),
performs self-diagnostics to ensure proper
operation and then sets itself to zero. A wake-up
message is always transmitted upon power
up. The scale is then ready for use. For best
accuracy, allow the scale to warm up for 5
minutes.
1. Insert the AC adaptor into an electrical outlet.
Connect the other end of the adapter into the back
of the scale (G). (See Figure 3)
PAGE 2 OF 15
INSTALLATION CONTINUED

KEYBOARD FUNCTIONS

zero Assigns the pan and whatever is currently being
weighed a value of zero. While the scale is determining
a stable weight reading, the display will indicate "BUSY."
sample Displays preprogrammed sample sizes (10, 25, 50, or
size 100 pieces).
count Instructs the scale to begin or resume counting. This
key may also be used to "update" the average piece
weight for increased counting accuracy.
setup/cal Instructs the scale to enter a setup or perform a
calibration.
a.p.w. Instructs the scale to accept an average piece weight
entry.
clear Clears the last number entered or operation requested,
and displays weight.
tare Instructs the scale to accept a numerical tare weight
entry. If a container is placed on the pan, pressing tare
assigns its weight as the "tare" (i.e. container weight)
and saves it in memory. The display will read net
weight (i.e. contents weight).
gross Toggles between the gross weight and the net weight.
(gross weight - tare weight = net weight)
print Scale sends displayed and stored or programmed
information to a printer, computer (or other RS-232
peripheral device).
units Converts the weighing units of measure (e.g. changes
from grams to ounces).
accum Sums and stores the results of multiple weighing or
counting operations.
i.d. Instructs the scale to store an identification number of
up to 25 digits (e.g. a part number or account number)
to be printed or transmitted to a peripheral device.
display Instructs the scale to recall the value stored in any of
the various registers (e.g. tare, accumulate, etc).
reset Sets all counting and weighing registers to zero. Clears
all volatile ID registers. Assigns the pan and whatever
is currently being weighed a value of zero. Displays full
scale capacity.
2. Once plugged in, the scale automatically turns on.
Figure 3
G
0521 IH-1096