How To Hang Your Ceiling Fan - Luminance Brands Kathy Ireland Home LURAY ECO El Manual Del Propietario

3. Ceiling Fan Assembly
3.13
The Fan comes with Black and White Wires that are
80-inches long.
Measure up approximately 6 to 9-inches above top of
Hanger Ball/4.5" Downrod Assembly (Figure 13).
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires.

4. How to Hang Your Ceiling Fan

CAUTION
!
To reduce the risk of injury, install the fan so that the
blades are at least 7 ft. (2.1m) above the floor (Figure 14).
WARNING
!
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box or circuit breaker
panel before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box or circuit breaker panel before
wiring. All wiring must be in accordance with National
and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
4.1
Disconnect Electrical Power to the Branch Circuit at
the Circuit Breaker Panel or Main Fuse Box before
attempting to install the Ceiling Fan to the Outlet Box.
(Continued)
1/2-INCH
6 TO 9
INCHES
Figure 13
AT
LEAST
7'
Figure 14
!
To avoid fire or shock, follow all wiring instructions
carefully.
A n y e l e c t r i c a l w o r k n o t d e s c r i b e d i n t h e s e
instructions should be done or approved by a licensed
electrician.
10
BLACK WIRE
WHITE WIRE
HANGER BALL
CEILING
FLOOR
WARNING
ETL Model No.: CF860