Light Kit Led Array Assembly Replacement; Tools Needed - Luminance Brands Kathy Ireland Home LURAY ECO El Manual Del Propietario

16. Light Kit LED Array Assembly Replacement

16.1
Disconnect Electrical Power to the Branch Circuit at
the Circuit Breaker Panel or Main Fuse Box before
attempting to install the Ceiling Fan to the Outlet Box.

Tools Needed

One Phillips Head Screwdriver
One Stepladder
16.2
Rotate and remove the Shade counter-clockwise to
expose the Light Kit Assembly (Figure 37).
Retain Shade for future reinstallation.
16.3
Loosened the Two Light Kit Adapter #6-32 x .375" Pan
Head Screws located in the Key Hole Slots.
Remove the remaining Light Kit Adapter #6-32 x .375"
Pan Head Screw (Figure 38). Retain for future use.
Rotate the Light Kit Assembly counter-clockwise to
disengage the Two Screw Heads in the Key Hole Slots
for removal of Light Kit Assembly.
!
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box or circuit breaker
panel before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box or circuit breaker panel before
wiring. All wiring must be in accordance with National
and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
ROTATE COUNTER-
CLOCKWISE
Figure 37
LOOSEN LIGHT KIT ADAPTER
PAN HEAD SCREWS (2)
ROTATE COUNTER-
LIGHT KIT ADAPTER PAN
Figure 38
HEAD SCREW (1)
26
WARNING
WARNING
LIGHT KIT
ADAPTER
RAISED
DIMPLES (3)
SHADE
FLAT AREA OF
SHADE (3)
LIGHT KIT
ASSEMBLY
CLOCKWISE
ETL Model No.: CF860