Light Kit Led Driver Replacement - Luminance Brands Kathy Ireland Home LURAY ECO El Manual Del Propietario

16. Light Kit LED Array Assembly Replacement
16.4
Disengage the Fan Motor Assembly 2-Pin Wire
Connector from the 2-Pin Wire Connector of the Light
Kit Assembly (Figure 39).
16.5
Install new Light Kit Assembly by following the
Section 5, Steps 5.2 through 5.4.
Restore electricity and verify function of the Light Kit.

17. Light Kit LED Driver Replacement

The Light Kit Driver is located in the motor
assembly.
The entire ceiling fan will have to be unwired and
removed from the ceiling outlet box.
If you feel that you do not have enough electrical
wiring knowledge or experience, contact a licensed
electrician to complete this repair.
17.1
Disconnect Electrical Power to the Branch Circuit at
the Circuit Breaker Panel or Main Fuse Box before
attempting to remove the Ceiling Fan to the Outlet Box.
Tools Needed
One Phillips Head Screwdriver
One Stepladder
FAN MOTOR ASSEMBLY
2-PIN CONNECTOR
LIGHT KIT ASSEMBLY
2-PIN CONNECTOR
Figure 39
!
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box or circuit breaker
panel before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box or circuit breaker panel before
wiring. All wiring must be in accordance with National
and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
27
(Continued)
WARNING
WARNING
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
ETL Model No.: CF860