Optional Installation Of No-Light Plate Assembly - Luminance Brands Kathy Ireland Home LURAY ECO El Manual Del Propietario

5.4
Place the Shade into the opening of the Light Kit
Adapter, aligning the Three Flat Areas on the Top Edge
of the Shade with the Three Raised Dimples on the
Light Kit Adapter and turn the Shade clockwise until it
stops (Figure 20).
NOTE: Periodically check that the shade is seated
fully clockwise in the Light Kit Adapter.

6. Optional Installation of No-Light Plate Assembly

Skip to Section 6.4 if supplied light kit is
not already installed.
6.1
Removal of the Shade from the Light Kit Adapter:
Rotate the Shade counter-clockwise to loosen from the
Light Kit Adapter (Figure 21).
Remove the Shade from the Light Kit Adapter
(Figure 21).
Store Shade in a safe location for future installation.
6.2
Removal of the Light Kit Assembly from the Light
Kit Adapter:
Loosened the Light Kit Adapter #6-32 x .375" Two Pan
Head Screws located in the Key Hole Slots.
Remove the remaining Light Kit Adapter #6-32 x .375"
Pan Head Screw (Figure 22). Retain for future use.
Rotate the Light Kit Assembly counter-clockwise to
disengage the Two Screw Heads in the Key Hole Slots
for removal of Light Kit Assembly.
5. Light Kit Assembly
(Continued)
ROTATE
CLOCKWISE
Figure 20
ROTATE COUNTER-
CLOCKWISE
Figure 21
LOOSENED LIGHT KIT ADAPTER
PAN HEAD SCREWS (2)
ROTATE COUNTER-
CLOCKWISE
LIGHT KIT ADAPTER
PAN HEAD SCREW (1)
Figure 22
13
LIGHT KIT
ADAPTER
RAISED
DIMPLES (3)
SHADE
FLAT AREA OF
SHADE (3)
LIGHT KIT
ADAPTER
RAISED
DIMPLES (3)
SHADE
FLAT AREA OF
SHADE (3)
LIGHT KIT
ADAPTER
LIGHT KIT
ASSEMBLY
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
ETL Model No.: CF860