Optional Installation Of No-Light Cover - Luminance Brands Kathy Ireland Home CF144LGRT00 El Manual Del Propietario

7. Optional Installation of No-Light Cover

NOTE: To use the No-Light Cover, the LED Light
Fixture Assembly MUST NOT Be Installed, or the
LED Light Fixture Assembly MUST Be Removed.
7.1
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
Removal of the Glass from the Lower Housing:
Rotate the Glass counter-clockwise and remove from
the Lower Housing (Figure 20) .
Store the Glass in a safe place for future use .
7.2
Remove one of the three M4 x 10 mm Pan Head
Screws from the LED Light Fixture Assembly
(Figure 21) .
Loosen the remaining two M4 x 10 mm Pan Head
Screws in the key hole slots (Figure 21) .
Rotate the LED Light Fixture Assembly counter-
clockwise for removal .
Replace the M4 x 10 mm Pan Head Screw previously
removed and tighten all three screws .
LOWER
HOUSING
Figure 20
LOWER
HOUSING
LED LIGHT FIXTURE
ASSEMBLY
M4 x 10 mm PAN HEAD SCREW
Figure 21
14
GLASS
U.L. Model No.: CF144L & CF152L