GE ATM06 Manual Del Propietario Y Instrucciones De Instalación página 6

Controls
Features and appearance will vary.
3
Air Conditioner Remote Controls
1. Power
Turns the air conditioner on and off.
2. Cool
Press the Cool button to Cool mode.
3. + and -
increase or decrease the Set Temperature or Timer.
Temperature range: 61°F to approximately 88°F (16°C to
approx. 31°C).
4. Sleep
Press the Sleep button, all of the display lights will turn
off after a while, but the Sleep light is always on. In
Sleep mode, the air conditioner will automatically adjust
the temperature and fan speed to make the room more
comfortable during the night. The set temperature will
automatically raise every 30-60 minutes and at most,
change six times until the set temperature is 81 or 82°F.
5. Timer
TImer.
Timer Off: The timed stop programmed by pressing the
Timer button. Set the rest time by pressing the + or - button
until the rest time displayed is to your liking then press the
Timer button again.
Timer On: When the unit if off, press the Timer button a first
time, set the temperature by pressing the + or - buttons.
Press the Timer button a second time. Set the rest time by
pressing the + or - buttons. Press the Timer button a third
time, confirm the setting, then the setting will automatically
switch on and will show the change on the display.
6
Front View
1
4
5
6
Back View
2
7
7
9
10
NOTE: It can be set to automatically turn off or on in
0.5 - 24 hours. Each press of the + or - buttons will increase
or decrease the timer. The Timer can be set on 0.5 hour
increments below 10 hours and 1 hour increments for 10
hours or above. The Set light will turn on while setting. To
cancel the set function, press the Timer button again.
6. Auto Mode
In Auto mode, the unit automatically chooses the fan
speed and the mode of operation (Cool, Dry, or Fan). IN
this mode, the fan speed and the temperature are set
automatically according to the room temperature (tested by
the temperature sensor, which is incorporated in the indoor
unit).
7. Fan Speed
Press the Fan Speed button to choose the fan speed
options. You can choose High, Medium, Low, or Auto in
Cool mode and High, Medium, or Low in Fan mode.
8. Display
By pressing the Display button, it wil switch off/on all lights
on the LED display.
9. Eco
When the unit is in Eco mode, the light will turn on. In Eco
mode, the until will turn off once the room is cooled to the
user set temperature. The unit will turn back on when the
room temperature rises above the user set temperature.
Before the compressor starts, the fan motor will run for a
while, then it will stop for a while, and will repeat to provide a
much more comfortable feeling and save energy.
10. Fan Only
Press the Fan Only button to activate Fan only mode.
49-5000421 Rev.0