Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
insulation. Use only identical replacement
parts. See instructions for Servicing of
Double-Insulated Appliances.
wARNING – To reduce the risk of
18)
electric shock – Do not use on wet
surfaces. Do not expose to rain. Store
indoors.
19) To reduce the risk of electric shock, this
appliance has a polarized plug (one blade
is wider than the other). This plug will fit
in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a
qualified electrician to install the proper
outlet. Do not change the plug in any way.
20) Extension cord - Make sure your extension
cord set is in good condition. When using
an extension cord, be sure to use one
heavy enough to carry the current your
product will draw. For lengths less than 25
feet, No. __16_AWG extension cord should
be used. An undersized cord will cause
a drop in line voltage resulting in loss of
power and overheating. (NOTE: Table 1
shows the correct size to use depending
8 8
on cord length and nameplate ampere
rating. If in doubt, use the next heavier
gage. The smaller the gage number the
heavier the cord.) To reduce the likelihood
of disconnection of lawn mower cord from
the cord set during operating:
I) Make a knot as shown in Figure 1, or
II) Use one of the plug-receptacle retaining
straps or connectors described in this
manual.
Table 1 Minimum gauge for extension
cords
Volts
120V
Ampere Rating
More than Not
more than
0-6
6-10
10-12
12-16
All-in-one Blower/Vac/Mulcher
Total length of cord in feet
25
50
100
AWG
18
16
16
18
16
14
16
16
14
Not
14
12
recommended
Figure 1
Method of securing extension cord
cORD
SET
Safe Operation Practices for Electric
Blowers and Vacuums
1) Training
a) Read the operating and service instruction
manual carefully. Be thoroughly familiar
with the controls and the proper use of the
equipment.
b) Never allow children to operate the tool.
c) Keep the area of operation clear of all
persons, particularly small children, and
pets.
d) Do not use the tool for any job except that
for which it is intended.
2) Preparation
a) Thoroughly inspect the area where the
equipment is to be used and remove all
stones, sticks, wires, bones, and other
foreign objects.
b) Do not operate the equipment when
barefoot or wearing sandals. Always wear
substantial footwear.
150
c) Operate the appliance only in daylight or in
good artificial light.
d) Always be sure of your footing. Keep a firm
hold on the handle and walk, never run.
12
12
12
3) Operation
a) Do not put hands or feet near or under
rotating parts.
b) If the equipment should start to vibrate
abnormally, stop the motor and check
APPLIANcE cORD
(A) tie cord as shown
(B) connect plug and
receptacle
EN
Publicidad
Tabla de contenido
