Black and Decker NST1018 Manual De Instrucciones página 8

• Insert the 3 /4 inch (19mm) Phillips screw
as shown in figure 4 to complete the guard
assembly (Phillips screwdriver not included).
TO ATTACH:
• Place the assembled guard over the
spool as shown in figure 5 and insert
the remaining three screws into the
guard as indicated by the arrows.
• Once the guard is installed, remove
the covering from the line cut-off blade,
located on the edge of the second guard
section.
Auxiliary handle attachment
Push the auxiliary handle onto the upper tube. Position the
handle so that the groove in the tube (a) is located in the
underside of the handle to match the rib (b) as shown in
figure 6.
Insert the handle bolt through the hole in the handle as
shown in figure 7.
4
5
6
7
8
a
b