Troubleshooting Guide - Kohler K-3524 Guía De Propietario

Seat Troubleshooting Guide (cont.)
Symptoms
1. The lights do not light up. A. The light feature is not turned
2. The seat does not
automatically go up and
down.
3. The seat goes only
partially up or down.
4. The seat does not get
warm.
5. The auto flush feature
does not work.

Troubleshooting Guide

This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or qualified
electrician should correct all electrical problems. For warranty service, contact your dealer or wholesale
distributor.
Kohler Co.
All manuals and user guides at all-guides.com
Probable Causes
on.
B. Electrical power is not
available.
C. The GFCI or RCD is tripped.
D. There is an electrical problem
with the outlet.
A. The auto open/close feature is
not turned on.
B. Electrical power is not
available.
C. The GFCI or RCD is tripped.
D. There is an electrical problem
with the outlet.
A. The seat calibration is wrong.
A. The seat heater is not turned
on.
B. Electrical power is not
available.
C. The GFCI or RCD is tripped.
D. There is an electrical problem
with the outlet.
A. The auto flush feature is not
turned on.
B. Electrical power is not
available.
C. The GFCI or RCD is tripped.
D. There is an electrical problem
with the outlet.
5
Recommended Action
A. Push the light button on the side of
the hinge until the blue light on the
button turns on.
B1. Verify that the power cord (wall) is
plugged into the outlet.
B2. Verify that the seat power cord is
plugged into the toilet power cord.
C. Reset the GFCI or RCD.
D. Verify there is proper (120V) power
at the wall outlet.
A. Push the auto open/close button on
the side of the hinge until the blue
light on the button turns on.
B1. Verify that the power cord (wall) is
plugged into the outlet.
B2. Verify that the seat power cord is
plugged into the toilet power cord.
C. Reset the GFCI or RCD.
D. Verify there is proper (120V) power
at the wall outlet.
A. Toggle the auto open feature on/off
and then touch either lid button to
start the calibration sequence again.
A. Push the heated seat button on the
side of the hinge until the desired
color light on the button turns on.
No color = off, Yellow = low,
Orange = medium, Red = warmest.
B1. Verify that the power cord (wall) is
plugged into the outlet.
B2. Verify that the seat power cord is
plugged into the toilet power cord.
C. Reset the GFCI or RCD.
D. Verify there is proper (120V) power
at the wall outlet.
A. Push the auto flush button on the
side of the hinge until the blue light
on the button turns on.
B1. Verify that the power cord (wall) is
plugged into the outlet.
B2. Verify that the seat power cord is
plugged into the toilet power cord.
C. Reset the GFCI or RCD.
D. Verify there is proper (120V) power
at the wall outlet.
1065104-5-A