Metabo HPT GP 18DA Manual Del Usuario página 12

Amoladora recta inalambrica
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
SPECIFICATIONS
1.
Cordless die grinder
Model
Motor
Rated speed
Max. Wheel Diam.
Collet Chuck Capacity
Type
Battery
Voltage
Weight
2.
Battery Charger
Model
Input power source
Charging time
(At a temperature of 68°F (20°C))
Charging voltage
Charging current
Weight
NOTE: The charging time may vary according to temperature and power source voltage.
WARNING
NEVER use an abrasive wheel, cutting wheel, or any wheel greater than 2" in diameter. Using such wheels
can result in wheel breakage, and will otherwise increase the risk of bodily injury from contact with the
wheel or wheel fragments.
Electric control
Soft-start
Overload protection
This protection feature cuts off the power to the motor
in the event of overloading of motor or a conspicuous
reduction in rotational speed during operation.
When the overload protection feature has been
activated, the motor may stop.
In this case, release the tool switch and eliminate
causes of overloading.
After that you can use it again.
Overheat protection
This protection feature cuts off the power to the motor
and stops the power tool in the event of overheating
of motor during operation.
When the overheat protection feature has been
activated, the motor may stop.
In this case, release the tool switch and cool it down
in a few minutes.
After that you can use it again.
12
GP18DA
DC brushless motor
7,000–29,000 /min
2" (50 mm)
1/4" (6.35 mm)
Li-ion battery Model BSL1830C
DC 18 V
4.8 lbs (2.2 kg) (BSL1830C attached)
UC18YFSL
Single phase: AC 120 V 60 Hz
BSL1830C: Approx. 45 min
DC 14.4–18 V
DC 3.5 A
1.1 lbs. (0.5 kg)
Restart prevention function
When the power is still switched on, the tool will not
restart when a battery is installed. This function can
be canceled once the tool is switched off .
Braking Function
Brake is activated when the switch is turned off,
stopping the motor's rotation.
Kickback Protection
The kickback protection feature cuts off the power
to the motor and stops the power tool in the event of
a sudden drop in the rotational speed of the wheel
during operation (for example, if the wheel locks during
cutting operation, etc.).
GP18DB

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Gp 18dp

Tabla de contenido