Maintenance, Transportation And Storage; Troubleshooting - PULOX PO-900 Instrucciones Para El Usuario

7. Maintenance, Transportation and Storage

7.1 Cleaning and Disinfecting
Using medical alcohol to disinfect the device, nature dry or clean it
with clean soft cloth.
7.2 Maintenance
A. Please clean and disinfect the device before using according to
the User Manual (7.1).
B. Please recharge the battery when the screen shows low power
alarm information.
C. Recharge the battery soon after the over-discharge. The device
should be recharged every six months when it is no regular used.
It can extend the battery life following this guidance.
7.3 Transportation and Storage
A. The packed device can be transported by ordinary conveyance or
according to transport contract. The device can not be
transported mixed with toxic, harmful, corrosive material.
B. The packed device should be stored in room with no corrosive
gases and good ventilation. Temperature: -40°C~60°C; Humidity:
≤95%

8. Troubleshooting

Trouble
The SpO2 and
Pulse Rate can not
be displayed
normally
The SpO2 and
Pulse Rate are not
displayed stably
The device can not
be turned on
Possible Reason
1. The finger is not
properly positioned
2. The patient's
SpO2 is too low to
be detected.
1. The finger is not
placed inside deep
enough.
2. The finger is
shaking or the
patient is moving.
1. The battery is
drained or almost
drained.
2. The device's
malfunction
Solution
1. Place the finger
properly and try
again.
2. Try again; Go to
a hospital for a
diagnosis if you are
sure the device
works all right.
1. Place the finger
properly and try
again.
2. Let the patient
keep calm
1.Please recharge
the battery
2. Please contact
the local service
center.
EN