12. Install the Door Panels
NOTE: Perform these installation steps from outside the bath/shower.
Install the Inside Panel
Lift the inside door panel with the rollers facing away from you.
Position the rollers on the inside rail of the top track.
Position the bottom of the door panel in the bottom track guide.
Check the panel for proper alignment and smooth operation. Adjust as needed.
After adjusting, align the inside panel with the wall jamb on the showerhead side of the
bath/shower.
Adjusting the Rollers
Remove the door panel.
Remove the roller screw(s) from the roller(s).
Move the roller(s) to another hole in the top frame flange.
Thread the screw(s) into the roller(s) and tighten.
Tighten the screws and reinstall the panel.
Install the Outside Panel
Lift the outside door panel with the rollers facing you and position the rollers on the outside rail.
Position the bottom of the door panel over the bottom track guide.
Check the panel for proper alignment and smooth operation. If adjustment is needed, follow the
adjustment directions above.
1034037-2-B
Top Track
Roller
Inside Rail
Inside Panel
Inside of
Bath/Shower
Outside Rail
Outside Panel
Bottom
Track Leg
12
Top Track
Roller
Inside of
Bath/Shower
Sterling