Kohler STERLING SP5300 Serie Manual Del Usuario página 5

Curved Base
Important:
3. Measure and Cut the Bottom Track
CAUTION: Risk of personal injury. Always wear safety glasses when cutting materials.
IMPORTANT! If your shower has a curve in the corners where they meet the sidewalls, be sure to
measure from wall to wall above the curves. Failure to measure above the curve or angle could result in
the bottom track being cut too short.
Measure from wall to wall at the flattest part of the shower ledge (dimension "D").
Mark dimension "D" on the bottom track.
IMPORTANT! For best results, use a 32-tooth hacksaw blade and a miter box to cut the bottom track.
Subtract 2-1/2" (6.4 cm) from dimension "D" and cut the bottom track to this dimension.
File the rough edges smooth where the bottom track was cut, taking care not to mar the finished
surface.
NOTE: If there are curves where the sidewalls meet the threshold, use a file to contour the bottom track
edges to match the curves.
Sterling
Measure
Here.
Measure carefully. If your walls are curved or
angled, measure above the curve or angle. Failure
to do so can result in an improperly cut bottom
track and can void the warranty.
Measure distance
"D" above curves in
the corners.
D
5
Measure
Here.
Angled Base
1034037-2-B