BEARWARE 302744 Manual página 24

Channel display
The weather station receives the signal of the outdoor sensor
automatically after all settings have been configured. You can switch
between the different channels using the "CHANNEL" button. The
channels of the outdoor sensor can be selected on the device directly
using a toggle switch.
Temperature alarm
With the temperature alarm, the base station will emit an
alarm sound if the sensor measures anything outside this tem-
perature range. The status of the indoor and outdoor alarms is
displayed using these icons.
8. Basic settings:
Note: Pressing the large "SNOOZE/LIGHT" button at the top of the housing
switches the backlight on. When the "SNOOZE/LIGHT" button is pressed
several times, the backlight is dimmed. Please note that the base station
does not respond to 2 buttons at the same time. Therefore, it is advisable to
press just one button at a time.
Press and hold the "MODE" button for about 5 seconds to configure the basic
settings. With the "UP" and "DOWN" buttons, you can change the values accor-
dingly.
By briefly pressing the "MODE" button in the time settings, you can confirm the
entry and proceed to the next option. In this way, you can change and customise
the following settings in the sequence mentioned below:
24
English