BEARWARE 302744 Manual página 26

9. Alarm setting
The weather station can store up to 2 alarm settings, which can be turned on and
off separately.
Setting the alarm
Press the "MODE" button to access the alarm settings. The alarm time is now
displayed instead of the time. Press and then hold the "Mode" button until the
corresponding alarm time starts flashing. You can make the desired settings using
the "UP" and "DOWN" buttons. Then press the "Mode" button again to save the
alarm setting.
Enabling the alarm
Press the "ALARM" button in time mode. An alarm icon is then displayed next to
the time. This means that the alarm is enabled. To disable alarm 1 and to enable
alarm 2, press the "ALARM" button again. Pressing the "ALARM" button again
enables alarm 1 and alarm 2. Both alarm symbols are shown in the display.
Both are disabled by pressing the "ALARM" button again. The symbols disappear
from the display.
Switching off the alarm
When the alarm is activated at the configured time, the backlight also turns on
automatically. The alarm is active for 2 minutes before it turns off automatically.
Press the "SNOOZE/LIGHT" button to cancel the alarm. If a snooze symbol is
shown on the display, this means that the snooze function is activated and the
alarm will go off again in 5 minutes.
Press any button to switch off the alarm.
26
English