Install The Upper Handle; Install The Grass Catcher; Install The Mulch Plug; Set The Blade Height - GreenWorks 82SP25M Manual Del Operador

Make sure that the two handle knobs are in the same
position.
WARNING
Do not damage or pinch the cables when you fold or unfold
the handle.
7.3

INSTALL THE UPPER HANDLE

5
4
5
1. Align the holes in the upper handle and the lower handle.
2. Put the bolts (4) through the holes.
3. Tighten the knobs (5) onto the bolts.
4. Do the same operation on the other side.
7.4

INSTALL THE GRASS CATCHER

8
6
1. Remove the mulch plug.
2. Open the rear discharge door (8) and hold it.
3. Hold the the grass catcher (6) by its handle and engage
the hooks on the slots (20).
4. Close the rear discharge door.
NOTE
20
English
7.5

INSTALL THE MULCH PLUG

8
8
7
1. Remove the grass catcher.
2. Open the rear discharge door (8) and hold it.
3. Hold the mulch plug (7) by its handle and fit it in the
discharge chute (9).
4. Close the rear discharge door.
7.6

SET THE BLADE HEIGHT

The machine can be set to different blade heights.
1. Pull the height adjustment lever (11) rearward to increase
the blade height.
2. Pull the height adjustment lever forward to decrease the
blade height.
7.7

INSTALL THE BATTERY PACK

13
15
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
9
9
11
10
14
WARNING
EN