Empty The Grass Catcher; Operate On Slopes; Operation Tips; Maintenance - GreenWorks 82SP25M Manual Del Operador

• Pull the speed control button in the direction of the
Turtle Symbol to decrease the speed.
5. Release the self-propel lever to close the self-propel
system.
8.5

EMPTY THE GRASS CATCHER

1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge door and hold it.
5. Hold the grass catcher by its handle and unhook it from
the slots.
6. Close the rear discharge door.
7. Empty the grass catcher.
8.6

OPERATE ON SLOPES

WARNING
Do not mow on the slopes with incline more than 15°. If
you are not comfortable, do not mow on a slope.
WARNING
Please keep a low self-propelled speed when you mow on a
slope.
• Do not go up and down on a slope, mow across the face
of the slope. Be careful when you change the direction on
a slope.
• Monitor the holes, ruts, rocks, and other hidden objects
that can cause you to fall. Remove all obstacles such as
rocks and tree limbs.
• Make sure that your footing is stable. If you are out of
balance, release the bail switch immediately.
• Do not mow near drop-offs, ditches, or embankments.
8.7

OPERATION TIPS

• Do not try to override the operation of the start button or
bail switch.
• Do not tilt the machine when you start it.
• Do not put hands or feet near or below the turning parts.
• Keep the discharge chute clean.
• Do not cut wet grass.
• Higher blade height is necessary for new or thick grass.
• Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other debris.
9

MAINTENANCE

WARNING
Remove the safety key and battery pack from the machine
before maintenance.
English
Keep the motor and battery pack free from grass, leaves or
too much grease.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
9.1

GENERAL MAINTENANCE

• Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
• Tighten correctly all the fasteners and caps.
• Clean the machine with a dry cloth. Do not use water.
9.2

REPLACE THE BLADE

21
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blades fully stop.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the blade nut (22) and spacer (23) with a wrench
or socket.
11
WARNING
CAUTION
CAUTION
CAUTION
23
22
WARNING
WARNING
EN