Step 1. Measure Cabinet Opening - Monogram ZWE23ESNSS Instrucciones De Instalación

STEP 1 MEASURE CABINET
OPENING AVAILABLE VS.
REFRIGERATOR WIDTH
Measure width of cabinet opening where refrigerator
will be placed, W.
Be sure to account for any countertop overhang,
baseboard thickness and any clearance desired.
Width, W, should not be less than 36 inches. The
refrigerator will be placed approximately in the
middle of this opening.
Rear Wall
W
REFRIGERATOR
Front
8
Installation Instructions
Baseboard
Thickness
or Countertop
Overhang
(Whichever
is Greater) Plus
Any Desired
Clearance
RH Side
STEP 2 BEFORE MOVING
REFRIGERATOR INDOORS
IMPORTANT:
Doors and passageways into
the installation location require a 31-1/2" (80 cm) min.
opening. If the opening is less than 31-1/2" (80 cm),
the top cap, doors and drawers must be removed. (See
steps 4–6.)
NOTE: Skip steps 4–5 if door removal is not required.
Go to page 10, Move The Refrigerator.
NOTE: To prevent damage, leave inside
packaging, door spacer and outside protective
wrap in place until the unit is moved to the
installation location.
31-1000602 Rev. 0